When trying to flash Eurovox 2 DnupMan cannot find any ports.

[Stabber]

My box would not pick up any channels after a power scan. I then made sure the keys were up to date and tried an auto scan which never worked. Next i returned to box back to factory settings and put in the up to date keys and ran an auto scan which gave me a limited number of channels. Then tried a power scan which failed once more. I then followed the instructions to the letter for flashing my box but Dnupman wont pick up any of the ports. I have made sure the ports are enabled and the drivers are up too date and still no luck. I have also tried it in boot mode and had no luck either... If anyone out there can help it would be very much appreciated...

[bluefire01]

Eurovox max V Help

i know this box works as i tried it at a mates house but on returning home i tried the same thing but getting no signals
I used to be on NTL years ago and obviously still have the ports in my house and used the screw in TV port
am i doing something wrong or is there a way of checking the signal ? HELP PLEASE
Kev

[chic.]

Hi m8 are you using a null modem cable? and what firmware is on it if its the lalest one then there is no need to flash it make sure you are scanning the right symbol rate and since you did a factory reset you will have to enable the emm again

[Stabber]

I've done everything you said and i am also still getting vm as i am online. I also get limited channels when doing an auto scan so i am still getting a signal all the trouble begins when i try a powerscan...

[chic.]

i know this box works as i tried it at a mates house but on returning home i tried the same thing but getting no signals
I used to be on NTL years ago and obviously still have the ports in my house and used the screw in TV port
am i doing something wrong or is there a way of checking the signal ? HELP PLEASE
Kev

do you have a subed box you can try if you dont pay any subs to ntl then there is a good chance you have been cut off

[chic.]

I've done everything you said and i am also still getting vm as i am online. I also get limited channels when doing an auto scan so i am still getting a signal all the trouble begins when i try a powerscan...

do a factory rerset again and check all your connections are nice and tight if you are using a splitter remove it and use a direct feed and do a power scan and make sure the symbol rate is correct, i had 1 of these boxes and it could take a few goes b4 it worked

[Stabber]

Ok Chic i'll try that and get back to you at least i have freeview at the moment.

[Stabber]

Sorry not to get back earlier but i now have all my channels back. I just kept trying and eventually it worked, thanks for your help...