i got the eurovox put the new firmware on it and i got most channels but i was missing a few for example skysports xtra and skymovies premier im new to this so im not sure what to do is there a code or a search that i can do to get them?
-
-
Need to know your area and provider info.I refuse to answer that question on the grounds that I don't know the answer. - Douglas Adams -
im on vm and im in london shall i get more specific on where i liveComment
-
Without going into full details just tell me what area of London. As I need to verify what ex provider you are on and what TPs are used in your area. A simple powerscan may do the job though.I refuse to answer that question on the grounds that I don't know the answer. - Douglas AdamsComment
-
i live in south west london how do i do a power scan and what does it doComment
-
A powerscan will find all the TPs, (frequencies) on your providers network. Press menu, installation, user installation, and you will see a list of frequencies. You will see your symbol rate it will either be 6952 or 6887. Should be 6952 as its an ex TW area. Just tell me which one and we can go from there. Also what firmware are you using. Press menu, config and system info and post what it says for SW revision.
BTW you must have scanned if you already have channels or did you get this box pre set.Last edited by satsmo; 15 August, 2008, 15:32.I refuse to answer that question on the grounds that I don't know the answer. - Douglas AdamsComment
-
i have 6952 and with the sw revision 1.0 st4 jul 15 2008 and when i bought the box i did scan.Comment
-
Well thats a powerscan. You should have 34 TPs, (frequencies), can you see 491000 as one of them in user installation. When you done the scan did you do it from the direct feed, i.e. no splitter.I refuse to answer that question on the grounds that I don't know the answer. - Douglas AdamsComment
-
i have 32 frequencies i havent got 491000 as one of them and i am using a direct feed.Comment
-
Go to menu- installation-user installation-ch edit(green button)add(red button)frequency-491.000-symbol rate 6887-press ok exit once press ok on the frequency you have just added ,then press manual scan.I refuse to answer that question on the grounds that I don't know the answer. - Douglas AdamsComment
-
it is searching now how long will this take and what channels will this get meComment
-
A minute and the ones you are missing hopefully.I refuse to answer that question on the grounds that I don't know the answer. - Douglas AdamsComment
-
if it takes longer than 1 minute what does that meanComment
-
It should find channels if the TP is valid, which that one is for you area and provider. If you are having problems it could be due to a weak signal input. I can give you a CDF for your area and provider if you like.I refuse to answer that question on the grounds that I don't know the answer. - Douglas AdamsComment
-
it might be a weak signal due to the bar being red and not going beyond 20% what will the cdf file do and how will it help meComment
Comment