No Signal and blank screen

[TREEFELLA]

Hi folks,

I have two ex5000 pvr's. I downloaded both last night with the new firmware. However, one is now working fine (apart from having a blank screen everytime I switch it on off standby, I then have to keep switching off at ther mains before it will work, bvecoming a tad annoying now), and the other worked for a couple of minutes and is now displaying 'No Signal' and only showing one screeen. I have done a re-boot and deep scan a couple of times but with no success, can anyone help please? This machine was not working (not up to date with the keys) before I installed new firmware, would this make a difference?

Thanks in advance for any help.

Regards

Treefella.

[nkw59]

try reflashing the boxes again.eurovoxes dont always take first time so give it a go.try finding an up to date cdf file for your area or do a scan connected to the cable feed,directly where the cable comes into the house.hope it helps....