konig cable tv amplifier

[spice]

hello guys need a little adive i bought the yellow konig got it setup intorduced the power all great now my nefew seen me adjust the control anyways i returned from the kitchen to find hes turn the 3 dials clockwise now these blocks are setup where you shouldnt have to adjust certain dials i know anti-clockwise is to raise the signal now heres my problem ive been told 2 storys 1 to adjust the lower signal channels on the low TP but that brings down the signal levels of all the high TP channels then i was told to do this signal booster and ballance on the higher channels as they need the signal power so i did now ive noticed a drop in signal but a raise/ballance in quality mine are 70 signal and around 65 quality but this is across all channels except the low TP channels its a little less can anyone whos used this or knows the workings confirm that this is whats meant to happen the block doesnt raise signals but does with quality and then ballances them out locking on the signal setting so thats the running setting from now on? ive not had any channels glitch since installing it but i was looking for a rise in signal or what ive said has happened is that whats meant to happen?

[cactikid]

if its reducing the glitching it must be working,no idea if it only does quality only or both.

[spice]

its weird m8 i know 1 dial ballances the 2 out both signal and s.quality but does drop the signal and i have noticed that when the signal are all set if i watch a channel thats from really low tp it brings the channel up to the level i set it at on the higher tp channel but its not the same for all channels some are showing a drop in quality to 50/58 without any blocking,glitching or drop in quality if it will sustain that im good with that it would be nice to hear from some one whos got 1 of these and can send any tips on best channels to set it up on or anything with the original settings would be huge havour.

[spice]

im going to add these to this incase anyone else runs into any issues the konig comes pre-set to maximum settings this is set with all 3 dials turned fully clockwise to bring the signal down you should only need to adjust the top dial GAIN CONTROL "Return Path" this dial when turned anti-clockwise starts to bring the signal down the 2 dials on the bottom slop control and gain control-forward shouldnt need ajusting but if like me and some others where the signal is weak you turn the bottom gain controller anti-clockwise slowly this will raise you signal but drop your quality use the slop controller to ballance them both out you will see them drop mine went to 70-signal and quality-58/65 finally use the top Gain Controller to strenghen the signals you dont see this with the eye but you do see and notice that the channels dont go blocky,glitch or break up.