error 5 on pace 4001

[a1gunner]

anybody no how to fix this know its something to do with nvram

[sundrum]

error

same problem here m8 but error 2 so sum help plz

[linus10]

error codes

see ists for errors

Here are some known error codes/meanings for ntl boxes:
Err1_ CRC fail across Primary Loader image.
Err2_ No longer used.
Err3_ Insufficient NVRAM
Err4_ Flash Fail or can't find platform object
Err5_ NVRAM not found
Err6_PSI buffer full download packet re-sizing required
Tuning Sequence Related Errors
Er10_ Unable to Tune to Last frequency
Er11_ Unable to Tune to Home Frequency
Er12_ Unable to Tune to any of the last NIT defined frequencies
Er13_ Unable to scan for a frequency
Er14_ Unable to scan for a symbol rate
Er16_ Unable to tune to hardcoded frequency
Input Stream Errors
Er20_ Timeout on receiving NIT
Er21_ Timeout on receiving PAT
Er22_ Timeout on receiving PMT
Er23_ Timeout on receiving object data
Er24_ Timeout on receiving TDT
Er25_ Sync loss has occurred on the input stream
Object Validation
Er30_ Object CRC Fail
Er31_ Object Digital Signature Fail
Flash programming errors.
Er40_ Insufficient Flash ( NAND Flash Specific )
ErrC_ Failed to Erase Flash Sector
ErrD_ Failed to Program a Flash sector.
ErrE_ CRC Failure of image just programmed into Flash

[chic.]

anybody no how to fix this know its something to do with nvram

reflow the nvram chip

[chic.]

same problem here m8 but error 2 so sum help plz

error 2 is a fault with the simm make sure its right in