If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
not being to bright on a pc, i'm abit suss about doing a download to my digivox 2007, i have the r232 patch lead and was wondering if some kind person could instuct me on the procedure.
cheers in advance
google bigmaq. d/l the tolbar and install. it will then be there permanently at the top of ie. from this you will have a constatnt update of key changes and future firmware updates. downloader 10 is on there too. i've attached it below.
good luck
I am nevts (steve) i am a newbie to all of this so please forgive me if i sound stupid.
Just like pizer i dont know what i am doing. I too bought a cable from mablin and connected my pc to my digivox. I hae dl10 and the appi file, i have followed the tut instructions and all seems well until after a short time I get a message saying failed to flash.
So what am i doing so wrong?
Any Ideas or is their any one nr swindon that i could take my digivox too to get it flashed?
Comment