Update Probs

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • creationblue
    Newbie
    • Dec 2010
    • 18

    #1

    Update Probs

    Hi

    Just did a S/W update without a hitch, then factory reset, disconnected the lan and did a successful channel search, but now only getting FTA channels, switched off everything and rebooted a few times but still no channels. Did the reboot wipe the box? and do i need to flash again?

    Thanks in advance

    Just
  • mcintyre1981
    Newbie
    • May 2009
    • 12

    #2
    Channels are down

    Comment

    • creationblue
      Newbie
      • Dec 2010
      • 18

      #3
      Just bad timing on my part then, typical

      Thaks fella

      Just

      Comment

      • cactikid
        V.I.P. Member
        • Sep 2008
        • 12017

        #4
        reboot box modem and router as in power off at rear for 30 secs then on

        Comment

        • bees2000
          Member
          • Dec 2009
          • 61

          #5
          Mine off at minute, try again later

          Comment

          • creationblue
            Newbie
            • Dec 2010
            • 18

            #6
            Originally posted by cactikid
            reboot box modem and router as in power off at rear for 30 secs then on
            Thanks fella, just did another scan and switched off but still nothing, seeing as others say its down ill look again in the morning, I was worried ide have to re-flash which involves digging out old lappy with correct port and it takes forever

            Just

            Comment

            • sigmadelta58
              Member
              • May 2010
              • 93

              #7
              if you disconnect LAN then you will only get FTA.
              Its the signal via LAN that unscrambles the others.

              Comment

              • dabs12
                Junior Member
                • Dec 2010
                • 34

                #8
                Got fta channels,sp.1&3also espn.other ch.e.g.gold.While we still have problems leaving box in stand by mode with power search mode on [see other settings in menue]

                Comment

                Working...