Kryptview Wont scan for channels

[bambam72]

i flashed a new box then updated by remote to the 29/11/2011 software, but when i scan for channels it keeps saying already exists and does not give me my tp list? i have got my own box that works fine but when i plug this in i cant seem to find channels??

[cactikid]

did you flash your box with a pc with xp and serial port and null modem cable?scanning from a live feed.

[ASEK]

and u have internet connected as well?

[lincsat]

You don't need internet connected to scan. It does give that problem when you do not have a signal, but I guess if you have another box there that works, that the cable is OK.

I would try doing a box to box software update from the good box to the bad box in case it's a bad flash. A box-to-box flash is usually better than a PC-to-box flash.

[bambam72]

how do i do a box to box software update?? like i said i already have a box here so my feed and all cables are fine as i plug my box in and all works fine..

[bambam72]

if i do a manual scan it just comes up failed!! i aint got a clue whats wrong here

[bambam72]

did you flash your box with a pc with xp and serial port and null modem cable?scanning from a live feed.

yes flashed with pc and with xp on, all went fine and downloaded ok

[maca]

do a factory reset and scan again...

[ASEK]

You don't need internet connected to scan.

no u don't but u need it to view channels.

[bambam72]

ive done a factory reset but still not finding any channels, ive tried it without ethernet cable in also same result...

[maca]

reflash it again it wont it..

[bambam72]

is there software to put it back to how i got it from supplier, maybe i could send it back as i dont seem to be having much luck....

[bambam72]

i will try to flash it again, see if i can put a diff flash on, see what happens

[faflefevre]

why dont you just flash it via box to box...
think as the boxes as master and slave the master box is the working one leave the master box switched on and connect via rs232 and leave the slave switched off..go into menu go into installation go into data download then hightlight data transfer then press ok....
then switch the slave box on then it should transfer (update) the do the same for channel tranfer (tuning)..
after doing this the slave box will be itentical to the master box

[ASEK]

ur scanning on cable alrite? in case ur scanning on sat chanells?