If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
you only need to change com port if using a usb serial cable as well as a rs232 null cable on laptop no need to change if using desktop. In the download section under arnet kryptview is where to locate the firmware and loader.
Quick question. Will it make any difference if i change the signal deviation? If yes, do i just do a reset and set deviation up or down before scanning? or could i just set deviation and then do a power scan? thanks
the signal devition up or down will only make better and only very slightly at that if your picture is a bit out of tune, as your channels are not even open it wont make any difference what so ever, best left alone m8 if your other channels are ok to view.
Comment