Kryptview

[VictorM]

Hi - new member to this community. I've recently had some problems with the Kryptview - currently using the April Firmware. The receiver is currently not picking up any channels and prior to that was ok for 20 mins at a time (unplug for 30 seconds and then was ok).

Anyone with any ideas to sove this problem?

Thanks

[bugaloo41]

Try putting the cable input at the back of box into the output channel, then do a rescan.

[jaytag]

do a factory reset b4 you do that scan

<--jaytag added 1 Minutes and 43 Seconds later...-->

do a factory reset b4 you do that scan if that does not work try putting firmware in again and then do a scan