DW800 Problem

[James_N]

Hi All,

I have today, recieved my Arnet DW800 box and put the december firmware on. However, whenever i change channels up or down, it crashes and "reboots" again.

If i browse channels via the EPG, thats fine and works ok, but when i turn the EPG off and channel flick up or down in the usual manner, it just resets its-self again.

Is this a bug or am i doing something wrong?

Cheers
James

[cactikid]

check you have loaded correct firmware i thought it was25092009.and not 700 or 750 box.

[James_N]

I put this one on:

http://www.digital-kaos.co.uk/forums/f99/kryptview-hd-dw800-firmware-manual-57148/

Many Thanks
James

[flattopguy]

hi
i have the same problem since the boxes, went down in edinburgh.
box just reboots then crashes

[James_N]

Glad its not just me having the problem then. Hopefully firmware will be out soon to fix it?

[flattopguy]

yes its a pain going to try and do a factory resest , if it stops rebooting and i can get into the menu.

[James_N]

mine isnt too bad, its only when i try and go up like 5 channels at a time, then it reboots.

[cactikid]

noticed extra info.
Kryptview HD - 25092009

Initial software. Some features such as EPG are still under development.

Expect improvments to these areas soon.

To flash, place the file "kryptview_hd_v101_25092009.cnl" in the root directory of a usb pen or hard drive and boot the set top box up.
When it says "FILE 1" press right to show the filename, and press right again to confirm the flash.

MANY THANKS TO THE DEVELOPERS

and the other place i got it from

("please note use the buttons ON THE BOX when flashing not the remote")
as i dont know what way you did it i will just post this.

[flattopguy]

hi
sorted the problem, unplugged v.m cable did a factory reset and loaded firmware.
im up and running again no probs.
hope this helps