KW A750 iConnector Firmware

[smirnoff_rules]

and leave on ss1 and have a drink .. sometimes thats a few minutes to clear

[satsmo]

Using the FW link above, follow these steps:

Please be advised that if you upgrade your A750 with the latest firmware, make sure your IConnect is powered OFF when doing the new channel scan.

Only reconnect it and power it back up again once you have a TV signal displayed on the TV (Usually channel 0000).

Once you power up the IConnect, it should take over the A750 and download a major update from the internet. This is normal and should be allowed to proceed (display shows on both the TV and the A750). Once the A750 display shows the word SUCC it is complete and you may now use your IConnect in the manner in which it was designed.

If you get the above wrong, the IConnect will sit there and only display 2 green LED's (power and connection). If this is the case, re-read the above and you have to start from the beginning (re-flash)

[smirnoff_rules]

does Kryptview_A750_25052010 not work now then ? my m8 has that on his and its ok

[akhlaq768]

its SUCC on the box and the TV says Module Update Success.. what now should i power it OFF and ON... as the remote wont let me exit

[satsmo]

Yes it works but the latest FW once flashed correctly has quite a few updates and a new menu item that has yet to be implemented.

The updates are improvements in relation to responsiveness, (without going into details) of the STB as well as the remote.

Suffice to say if it aint broke don't fix it can also apply in regards to using older FW, but the latest is always advised.

[satsmo]

its SUCC on the box and the TV says Module Update Success.. what now should i power it OFF and ON... as the remote wont let me exit

How many LEDs showing on the IConn? You may power on and off if you like either way.

[akhlaq768]

Only two lights are showing... now

This is my process i took (please correct me if ive done anything wrong)

Flashed Box
Connected Box to feed and scanned the program
Power up the i-Connector
Wait and see....

[smirnoff_rules]

1 turn off router
2 turn off box at rear
3 unplug power on i-conn
4 reconnect all and leave on skysports 1 or a few minutes

[akhlaq768]

will give this a go now

[akhlaq768]

also, am i using the write TP for Birmingham - 41011?

and i don't have channel 0000

[akhlaq768]

1 turn off router
2 turn off box at rear
3 unplug power on i-conn
4 reconnect all and leave on skysports 1 or a few minutes

UPDATE - still having no luck with this... :-(
any suggestions?

[akhlaq768]

Box is now showing FAIL every couple of seconds or so...

Should i re-flash the box again?

thanks

[cactikid]

did you get a list of channels when scanning,and are you using correct net id

[akhlaq768]

Yes I got all the list of channels when scanning and can select them but they still scrambled, but that’s understandable as the I-connector isn't working, the net id for Birmingham im using is 41011

[akhlaq768]

i still have no luck have tried re flashing a re scanning i still only have 2 lights, one of which is flashing every 5 secs or so.

any adv???

thanks.