ONE ON ONE OFF

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • camelv
    V.I.P. Member
    • Nov 2008
    • 1202

    #1

    ONE ON ONE OFF

    Got 2 sv7's both with same f/ware on ,one is working fine and saying connected and the other is saying not connected and will only show fta ,tried all the usual stuff ,like rebooted everything but still no joy,any ideas anyone.
    thanks .





    sigpic
    its the stuff we think we know that stops us all from learning
  • peggybobby
    Junior Member
    • Sep 2009
    • 33

    #2
    hi camelv,

    check to see if both ips are the same ,
    go into network, ip setup and change ip address by 1 digit at the end so you dont get conflict of the 2 boxes with same ip so if 1st box is 0.2 at the end have the 2nd box say 0.3 at the end
    rgrds
    peggybobby

    Comment

    • cactikid
      V.I.P. Member
      • Sep 2008
      • 12017

      #3
      dont think it matters on a cable box,but i have seen same problem elsewhere,i wonder have they changed something inside like a new chip that current firmware wont work on..

      Comment

      • candyman
        Junior Member
        • Jun 2010
        • 26

        #4
        Have you tried disconnecting completely the one that works so that only the fta box is connected ?

        Comment

        • camelv
          V.I.P. Member
          • Nov 2008
          • 1202

          #5
          Originally posted by peggybobby
          hi camelv,

          check to see if both ips are the same ,
          go into network, ip setup and change ip address by 1 digit at the end so you dont get conflict of the 2 boxes with same ip so if 1st box is 0.2 at the end have the 2nd box say 0.3 at the end
          rgrds
          peggybobby
          ip's were not the same m8 and when i try to change ip in manual it just goes back to same one.





          sigpic
          its the stuff we think we know that stops us all from learning

          Comment

          • camelv
            V.I.P. Member
            • Nov 2008
            • 1202

            #6
            Originally posted by cactikid
            dont think it matters on a cable box,but i have seen same problem elsewhere,i wonder have they changed something inside like a new chip that current firmware wont work on..
            ta m8, but box is about about ten months old and worked with the carling f/ware in before they last went down.





            sigpic
            its the stuff we think we know that stops us all from learning

            Comment

            • camelv
              V.I.P. Member
              • Nov 2008
              • 1202

              #7
              Originally posted by candyman
              Have you tried disconnecting completely the one that works so that only the fta box is connected ?
              Done all that ,thanks m8.





              sigpic
              its the stuff we think we know that stops us all from learning

              Comment

              • cactikid
                V.I.P. Member
                • Sep 2008
                • 12017

                #8
                not 2 sure but does the 1 that does not connect have the new firmware 2.12,i would suggest a reflash again with clean usb stick and a fresh download in case file got mixed up

                Comment

                Working...