STARVIEW POWER GONE!! help!!

[mod2000]

Try here mate

JTAG |

[Anup509]

Thanx ill giv it a try

[larry okun]

i was not the original person that posted the thread, however, i think the poster would have got his question answered by now

[Anup509]

Hi Ther, I got Starview 1 Clone, I put the wrong software in, so the box is dead now, there's just a clickin noice coming when i swict it ON, i tryed to JTAG with SKYMAX 2.2, It Connects Then i clicked on Erase and then i clicked on Write and in that i selected the new firmware which is CryptStar-v1.5-Core257, it starts wrtting but at the End it says it Failed. This is the error: "Error writing flash at address 80000000 ACK = 00000000"

[mcgeoff]

Are you setting ard flash at 2mb(7fe00000) and then flash with file STARVIEW-29LV160 .bin below disconnect jtag and then flash with clone safe firmware.

[Anup509]

Hay thanx that worked, but still theres no LED on the box. What do i do after it finish writting?

[alanseries1]

What you need is a volt meter to check the power board is delivering the the three different voltages from the ribon cable to the cpu board cant remember off hand what they are but its something like 3 , 7 , 12 volts . the conection to the ribon on the power board has the voltages printed next to it . there are two ground conection also at the same point . This will prove if the power board is at least delivering the power to were ist needed. Dont just assume the capacitors are ok as I had to replace two on my power board and they showed no blown tops or any indication they were faulty one was the C15 and the other C 11

[Anup509]

Hay thanx its working now, i jst needed to wait, wow m so happi, fanx alot people for the help. Yeeeeeeeeeeeee... Best FORUM

[ttcube]

l had a same problem b4 on my starview two wat l did was solder out the transformer and back in after a few seconds and it worked till today.