Starview 2 in Ireland stuck on 0% updating

[fatboyie]

Hi. I have a bit of a problem. I was on 4.54 before and the box suddenly didn't want to update the codes anymore (stuck on 0% for hours). So I decided to upgrade to version 4.57 (from this forum, thanks) and tried again. I reset to the factory settings, switched the EMU on and the same problem happens. I also tried the latest codes I found (23-12) and tried it again, but got the same problem. Is there anything I'm doing wrong? It does find the correct amount of channels during the scan.

Thanks

[khenryashley]

Try going into the secret menu and pressing the default button then turn emu on.
Cheers
Ash

[fatboyie]

Thx M8. Tried that already, with the same result...

[khenryashley]

Try starting from scratch again.
Do a factory reset then flash the box
First of all make sure you have the latest firmware on the box. Should be 4.57
You check this from the menu - System setup/System information
Once you have flashed the new firmware go into the menu and do a another factory reset.
Rescan the box choosing your local cable provider.(N*L etc) Choose english-autoscan
Once the channels have saved, exit out 3 times.
Press menu and then 1570 you will go into another secret menu.
Highlight the default key and press ok.
Then scroll down to the emu and turn it on.
Exit out and put your box onto a S*y sp1
Wait for it to update. This may take a while.
You should be now all up and running

[satsmo]

Just go to Sly 2 and with emu on it will update in a minute or so. AU in Ireland differs somewhat in relation to this box and some others.

[fatboyie]

Thanks both of you. It worked a treat.