Starview 3 The box super problem

[vtorres]

Erm i am very inexperienced in this department and do not want to disturb the electricity or anything so what do i do ? Just plug it in to the adapter like usual ?

[cactikid]

the same plug you get on a tv,kettle
13 Amp Plugs & Fuses
and the wires are connected to n and l
adaptors can be the cause so get rid of them.

[vtorres]

I am sorry but i cannot wire all that up thanks for your help but it would be too much of a job for me. Would it be safe to use this adapter LGA-Selectric LGA Selectric LG8780 13 amp shaver socket adaptor fused 1 amp white moulded finish

[vtorres]

Would it be safe to use the shaver adapter with the 2pin plugged inside it ?

[cactikid]

I am sorry but i cannot wire all that up thanks for your help but it would be too much of a job for me. Would it be safe to use this adapter LGA-Selectric LGA Selectric LG8780 13 amp shaver socket adaptor fused 1 amp white moulded finish

no way it will blow,bring it to an electrician if you cant do it yourself,buy a diy book for house as their will be a few guides to help you.
[ame="http://www.youtube.com/watch?v=ZN_-_eRDvf0"]YouTube - How To Wire a UK 13 amp Plug[/ame]

[vtorres]

ok sorry i thank you all for the help it just im a confused guy.

[cactikid]

and remember buy a 3 amp fuse also.

[vtorres]

Ok i took your advice got an electrician in and changed the plug to 3pin with the amp fuse but the problem continues however when unplauging the cable there is no reboots so could that point towards a cable issue ?

[vtorres]

After people suggesting to update to 8.02e i did so yet the problem still continues with the 3pin plug. Should i give up ?

PS Really sorry if i am annoying fellow posters.

[mtv1]

open the box m8 hoover out the inside might be dust tripping it out worth a try good luck

[mtv1]

ok m8 theres 3 or 4 Philips screws at the back and side of your box open these and the top cover will come off easy then check all connections clean any dust and most important make sure the box is plugged out there might be some current still in the box so take care

[vtorres]

Ok i give up. Posted problem to Starview Repairs UK and they replied "Its a processor failure no fix" So i officially give up thanks all for your input and help.

[onkar_222]

whats the current code

[maca]

whats the current code

hello and welcome to dk look here BigMAQ Toolbar Download