how do i transfer software onto the box??

[hkhan]

i dont know how to transfer the software onto the box?? need help people

[tal1]

download the software from the downloads section on this site onto a usb memory stick (aka flash drive). Then plug the memory stick into the usb slot at the back of the Starview box. Press menu button on your remote control.Then scroll down to usb. Then press arrow right (volume button) to put usb on right side of screen. Press ok. Then scroll down to your software on the usb which should be yellow on a blue background.Press ok.wait for it to finish loading.then press exit and go to installation and automatically load all the 200 and something new channels. Enjoy !

[larryoke]

i dont know how to transfer the software onto the box?? need help people

If you have downloaded the firmware you only need to get the tut by DESSERTDOG and follow the simple instructions
SV5 tut : (8.0 KB)
Starview 5 - firmware

[DESSERTDOG]

i dont know how to transfer the software onto the box?? need help people

Simples READ THE TUT

[larryoke]

download the software from the downloads section on this site onto a usb memory stick (aka flash drive). Then plug the memory stick into the usb slot at the back of the Starview box. Press menu button on your remote control.Then scroll down to usb. Then press arrow right (volume button) to put usb on right side of screen. Press ok. Then scroll down to your software on the usb which should be yellow on a blue background.Press ok.wait for it to finish loading.then press exit and go to installation and automatically load all the 200 and something new channels. Enjoy !

Make sure the box is turned off before inserting/taking out the usb, unless you need a new doorstop!