Starview 4 super usb + signal booster

[willhous]

I have been trying to get signal from box to bedroom tv's using a signal booster, so far no success. I run the tv out from box into the aerial socket on booster which then goes to bedrooms via two cables. Any ideas would be appreciated, worked before with chipped box but not with the starview. I tried splitting the signal before it goes into starview but that didnt work either

[ramjet]

just looked on the net and there is no mention of the sv4 usb having an rf channel modulator , so check the manual and see if it has one between rf channels 21 and 69 like the older ones had

if it hasnt , you will need a scart to uhf console adapter plugged into the scart or phono outputs to send the rf signal to the booster

[willhous]

I checked the manual it says the box has rf modulator on tv out and ant in connections. should I try just connect to tv without using the scart connector

[dell_xps]

Go into the menu m8 and select rf modulator, try it on different frequency, I'm sure it goes something like that.It's been a while.

[dell_xps]

RF modulator, set it to PAL I.

[ramjet]

yes , plug a tv into the rf out and try tuning it to the same channel as in the menu ( between 21 and 69 ) , then try doing the same at a remote tv fed by coax cable , and as said above set it to pal I

if necessary change that rf channel so you dont get any conflicts with any other channels you may have plugged in from an aerial

[Prakman]

Starview 4

Hi, does anyone know how iget my area code please?

[dell_xps]

Hi, does anyone know how iget my area code please?

M8 your hijacking someone else's thread, what code are you on about,5A01 ? etc
Who's your provider?