Prius SRS fail

[catalinux]

Hi,
I've just tried to erasea SRS from a S220 chip to get rid of airbag light on the dash, I had the possibility to copy from a similar device from another Prius all the data from the chip, and then copied to my bad chip. Surprize, didn't work. I'm new in this field & may be I did something wrong, I have a VP-290 Wellon Programmer, hex data to read the buffer, I copied the buffer from the good chip, I erased the bad chip and installed the buffer from the good chip, but didn't worked.
Can anyone help me please, and say what I did wrong?

[patkins]

Hi catalinux. Your question may not be seen here. If you could post it in the relevant auto section you will probably receive a quicker reply. Good luck.

[catalinux]

Thank you, i'll do that

[visavis88]

i would try to erase all EEprom memory and try how it works. if fail, look for codes, or replace the module

[maca]

i would try to erase all EEprom memory and try how it works. if fail, look for codes, or replace the module

update http://www.digital-kaos.co.uk/forums...e-read-154246/

[rrob311]

I would check the schematic on what triggers the SRS light and I would pull the fuse if it has one for it or the relay.

[kingkey]

check your soldering ,if your sure the logic is correct , also are you sure you have put the chip on the right way around ?

[swat cat]

If you could post it in the relevant auto section you will probably receive a quicker reply. Good luck.

what auto section.... they closed if for moust of all