blade 7000 cline problem

[dhally]

hi members can some1 please help me i have a blade 7000 which wont connect to my dm600 which is set up as a server,my dm600 uses oscam ,i have put the cline in by usb and manualy but still shows as diconnected any help would be grateful thanks dhally

[Rodbouy]

what firmware are you using on theblade? older fw doesnt connect wity the generic cccam, you should see in oscam logfile.

Change the protocol to newcamd and try that.

remember and change your port.

[fes_786]

he's using oscam as card reader

cccam 2.1.3 as server

in warning.txt it says login failed

username and pass are same and ok

[Rodbouy]

you never answered what fw he is using tho

Im sure the cccam version on older fw was 2.1.1

[dhally]

on the blade the firmware is 1.22p have checked the cline which is ok as for cccam it is 2.1.3 on my dm600

[dhally]

on the blade the firmware is 1.22p have checked the cline which is ok as for cccam it is 2.1.3 on my dm600

can anyone help please on the above,can it be that the blade cccam dont work on oscam reader

[jon48]

blade

can anyone help please on the above,can it be that the blade cccam dont work on oscam reader

yes m8 it does not work on the blade its only newcamd and cccam

[Rodbouy]

What does your log say when the blade is trying to connect ?

Have you even tried using Newcamd on the blade?

Just activate the protocol in oscam.conf under a different port than CCcam.

Keep the same user details in OScam.user

Add details to Newcamd line in the blade.