Best 80cm dish?

[mdt]

ive installed quite a few 1m iss motorised dishes using L brackets and never had any problems although they can be difficult to get plumb. i have also seen varying quality brackets with some really poor ones.. i always use t+k brackets now and better components but when i first started installing as a hobby about 5 years ago i used them as i purchased full kits as price was king and thats what you were given. regards mdt

[marcus1975]

hi
i have t+k brackets with my dish set up

see below for my ultimate set up

[bj1]

i have always fitted L brackets and i buy them in boxes of 5
and there has been times where i have found dodgey welding
on them but had no problems getting them replaced by the supplier, i always check the welding and buy the L brackets
that have 8 bolt holes in as 4 is not enough.

[canford]

Has anyone used these motors:NEW HORIZONS NH-210 DISEqC 1.2 MOTOR.
NEW HORIZONS NH-210 DISEqC 1.2 MOTOR FOR SATELLITE TV | eBay

Read a lot of good reviews, but you cannot beat an installers experience!

[digicon]

Has anyone used these motors:NEW HORIZONS NH-210 DISEqC 1.2 MOTOR.
NEW HORIZONS NH-210 DISEqC 1.2 MOTOR FOR SATELLITE TV | eBay

Read a lot of good reviews, but you cannot beat an installers experience!

Put it this way put an extra ?10 in the pot and get a Superior Darkmotor which is not another Motek Clone nuff said.

[chopps]

Hi, I'm not a professional installer, but I bought and installed that CDTronix motor last summer and so far so good.

chopps

[rigsby71]

Has anyone used these motors:NEW HORIZONS NH-210 DISEqC 1.2 MOTOR.
NEW HORIZONS NH-210 DISEqC 1.2 MOTOR FOR SATELLITE TV | eBay

Read a lot of good reviews, but you cannot beat an installers experience!

yes, they are crap....keep losing positions every 24 hours.

Alsat Dark Motor...never had a sniff of a problem with these.

I am taking this New Horizion motor back tomorrow to swap for Dark Motor.

[blueflash234]

digicon any links to the german supplied gibertini's ,was out realigning my dish at the weekend and noticed the pole slightly out of plumb over tightening the brackets on the pole has bent it very slightly of plumb i think you are better of with a scaffolding pole the quality is not there

thanks cat010

[digicon]

digicon any links to the german supplied gibertini's ,was out realigning my dish at the weekend and noticed the pole slightly out of plumb over tightening the brackets on the pole has bent it very slightly of plumb i think you are better of with a scaffolding pole the quality is not there

thanks cat010

you can try HM-Sat i use these most of the time an 85cm delivered from there is around ?68 although some on ebay can be had ?75 so not much of a saving really