Rf Mod - cracking up

[awhitey44]

hey guys
attempting to run dm500s to 2nd tv using rf mod. scart goin from dm500 to rf mod then back out into tv. im running 20m coax from rf mod to 2nd tv, all im getting when scanning 21-69 is a fuzzy pic, i got it working on channel 69 for 10mins. turned off tv back on and no signal, went back to 69 to scan but nothing.
any1 know any ideas

[tkm18]

DM500s are ropey with mods,i tried and had the same problem, worked fine with an old openbox, so i reckon it was the dm500 that was causing the issue.

[fac51]

Most modulators don't work with the 500 clone or genuine but these do 100%

http://www.labgear.co.uk/category/accessories/other-products/uhf-mini-rf-modulator-pal-1-pal-bg-/1009/1051/89/

[dontwant2payafortune]

My mate had same problem... He bought a booster for bog standard aerials, implemented it in the set up( dnt know where ) but that solved his similar problem,,,, only then to find out he couldn't control the 5 million magic ees he had scattered about hi mansion,,, again,,, triax tri link kit solved that bad boy.. Good luck!

[dontwant2payafortune]

hey guys
attempting to run dm500s to 2nd tv using rf mod. scart goin from dm500 to rf mod then back out into tv. im running 20m coax from rf mod to 2nd tv, all im getting when scanning 21-69 is a fuzzy pic, i got it working on channel 69 for 10mins. turned off tv back on and no signal, went back to 69 to scan but nothing.
any1 know any ideas

Check ALL connectors male/female/barrels... Had a nightmare and found one shitty connection or dodgy section of cable can make difference. Doubt it's image etc. shouldn't need booster for short run like that m8. Good luck.