Installing enigma2 on hard drive cuberevo9000

[mjamil]

Hi can anybody help me please how to install enigma 2 on cuberevo9000? i install a new nlb image and looking for help

[aftermath]

Dont got for a fast SATA HDD get SATA 1.0 , go for a 5400rpm one and not a 7200rpm one

its the same way as you install E2 to a usb stick, more or less

from dgs based image

ftp image to /media

in telnet

cd /media
tar xvzf "imagename.tar.gz" without the "

wait untill image stops unpacking

then

sync
sync

now look for a multiboot config and flash over the top of DGS based

press and hold the relevent key to load from HDD, normally "6 "

[mjamil]

my hard drive is built in reciever 500gb and don,t know how to install e2 on it in flash nlb image

[aftermath]

my hard drive is built in reciever 500gb and don,t know how to install e2 on it in flash nlb image

from nlb image..

ftp to /media and ftp you e2.tar.gz image into there.

now in putty or other telnet programme.

login
name = root
password - relook
then
cd /media
tar xvzf "image" you ftp`d to the media folder, example tar xvzf E2.tar.gz

once its unpacked
at the command prompt type
sync, then press enter.
then
sync ..

now you need to flash the multiboot config ( from DGS main site )over the top of NLB 9 pC editor, same way as you flash NLB image )
switch off at the back
switch on while pressing the number 6 key on remote control until you see " multiboot 6 " in LCD.
it should say "wait 3 mins after a short while "