MGcamd 1.35 running well on my itgate

[Borgy100]

Hi Deeboi,

Sounds like there is definately something missing from the Edg image. i am like you and have a fixed dish at 28.2E but now want to go down motorised route but i have checked me Edg image and no USALS present. I think the only solution is to try and see if there is another Edg image out there for the cncverted TGC200 that has USALS or I'll have to swap over to UKUR image if i go motorised, as i know set up etc is easier with USALS.

any info or suggestions anyone else has would be grateful!

Thanks again

[deeboi]

Hey B~~~~, I was wondering if you'd be able to either attach the MGcamd you have running on your box or PM me a link to it.
I've tried loads of versions and can't get it to install properly, I'm trying to add it to the blue button.

Thanks.

(I had this problem with CCcam too and after downloading lots of different cccams from here I eventually got one that worked and installed properly and it was one that someone had taken from their own box)