Openbox s10 BISS Entry

[Rosesheroes]

Hi

Is there any automated way in which BISS keys can be added to an Openbox s10?

I know that you can add them through Network Setup - CCcam Client Setuo - Update files through USB.

However, all the BISS files which I have seen to date seem to be in a different format to that which is required by the S10.

Therefore is there a specific format for s10 BISS files and secondly what is the best source of those files in that format?

Thanks in advance

Rosesheroes

[slugworth]

network setup,manage constant.cw
green button on remote,sids and pids must be in hex format,not decimal.After entering,if the key works save to usb and follow the same format when editing on pc.

[slugworth]

lan manager

the stbhd_lan_mm program help screen shows the proper format.Enter info in the receiver manage constant.cw and save,even if it's incorrect.Transfer the constant.cw to pc with stbhd_lan_mm and edit with that.Don't forget to save after editing(the floppy disk icon) then transfer back to receiver.
Good luck with biss,I could only get old firmware(prior to may 4 2011) to work.

[slugworth]

csa rainbow table tool

for providers that you don't have biss keys for,seek out a program called csa rainbow table tool.Assuming you have a nvidia video card with cuda support,you can run that program to make a rainbow table.Record scrambled biss for about 5 minutes and run the program on the scrambled .ts file.
I have never used it,since I don't have the correct video card $$$