Help With Openbox S9

[sephton19661]

Hi I have a Openbox S9 i have set it up and all is ok but i have a slight problem scanning for channels.

I Have a fixed dish pointing to 28.2E when i do a scan with the Lnb frequency set to Universal 9750-10600 it misses quite a few transponders off. I have loaded the latest channel setup from the downloads section from this site and the channels from the missing transponders are there but says no signal. However if i change the Lnb Frequency to 10050 these channels start to clear but the channels on the found transponder cease to work no signal. So what i have to do is keep changing the frequency of the lnb to get all the channels which i know is not right. i have a dreambox 500 SD all is fine with that it seems like its the HD channels that i have a problem scanning mostly movies.
Does anyone have any ideas how to fix this problem

Cheers

[mtv1]

no.1 check is it a clone if not or it is put the latest SAFE filmware in it .. also check connections lnb would be last port of call check connectors f type no wires earthing seems a small issue good luck m8

[Manic01]

Back up list,
Factory reset, delete all transponders/channels.
Blindscan just to see if working ok.
Make sure you leave 9750-10600 universal for lnb settings.
I had a channel list from here for 28.2e and loads of TP were miles out as the persons lnb settings was incorrect who made the channel list.

[slugworth]

and the only receiver connected to the lnb when you scan

[sephton19661]

Still Stuck with this

I have done a factory reset done a single satellite scan on 28.2e with the lnb frequency set to Universal 9750-10600 when its scanning 10 transponders fail and it lists 561 channels all hd movies are missing and loads more.
However
i done a 2nd factory reset and used lnb frequency set to 10050 done a 2nd scan only 2 transponders fail all hd channels are now showing and a total of 1028 channels if i leave the frequency set to 10050 they will work but most of the entertainment will not work aswell as sports. Only when i change to Universal 9750-10600 frequency them channels will work but the hd movies will not work i have to change the frequency all the time. i am doing a blind scan. i have not updated the firmware on the box it is running the original firmware will updating the box get better results when i scan?? pulling my hair out now cheers

[sephton19661]

Fixed my small problem was quite hard to fix in the end but i actually ripped my Mini Dish off the wall and set up a brand new motorised dish problem solved all channels scanned fine but only 2000 channels on the open box s9 so cant scan all desired sats now

[Manic01]

2000 channels , lot more than that.
Make sure to delete all radio stations and unused tp's.