Openbox s10 reboot problem.

[mg1963]

I just got an Openbox s-10 and I'm using a Digipower DiSEqC H-H motor model SG-2100, I'm having problem with-it rebooting, When when trying to setup the Sats for motor,I know it's not the motor or coax I've tried setting up the dish and motor with a Coolsat 6000 and it works fine.
Any suggestions??

[mtv1]

fiitc........... get a dreambox800se

[rigsby71]

Been done to death this question.

S10 is pretty useless with motors.

S9 is much more stable with motors.

[rrob311]

I had the same problem with the same USALS motor and Openbox S10 receiver. What I found is that the power from the supply was dropping when trying to drive the motor. Through help from a friend at another site they found that the 8 legged chip on the power supply (SD4841p) is underrated for the power supply therefore causing power loss when moving motor. I was able to source the proper SD4844 chip and solder it into the power supply and PROBLEM SOLVED. I have not had 1 reboot since replacing the chip. I hope this helps everyone. The chip was 6$ or so shipped.