iv lost o.8 thor

[mario123]

ok my problems are iv lost o.8 thor at the start coz i just to get it i thought it was my channels settings but iv changed over and still no joy.

see sometimes my dish dosent move when i change channel and i have to go into transponder scan to get it to move and thor isnt listed there.
i think thats wat my problem is. does anyone know how i can add it back in there again?

[nellyscossy]

if you go to satellite config then open one of the dropdown boxes, thor should be there then save.then go to rotor setup and drive the dish to 0 then position the dish a little east or west and you should then get a lock. is so then scan the transponder and you should get the channels back

[mario123]

if you go to satellite config then open one of the dropdown boxes, thor should be there then save.then go to rotor setup and drive the dish to 0 then position the dish a little east or west and you should then get a lock. is so then scan the transponder and you should get the channels back

thor was in satellite config. send my dish dish to 0 is not working. can u not get send to x working for this sat?
is there any reason y its not showing up on transponer scan.

i notice i using the carlton motor setting and they have thor as 1 west instaed of 0.8 west could this be it?