4x1 DiSEqC switch setup ?

[r1c4ard]

I am having real trouble setting up a Wave Frontier T90 dish, Global UK Communications 4x1 Switch and Dreambox DM500s with Gemini Image
LNB?s at 13, 19, 23 and 28 all with good signals
Switch Lnb 1 ? 13
Lnb2 ? 19
Lnb3 ? 23
Lnb4 ? 28
RX ? DM500
I just cannot get the receiver to switch to any LNB ??? any HELP would be appreciated.

[cauliflower69]

The switch may be faulty m8. Had that b4.

[r1c4ard]

The switch may be faulty m8. Had that b4.

Bought a new switch today as other one had a little surface rust when was exposed to water wanted to rule the switch out I think its more with the dreambox config from user error

[cauliflower69]

Can you borrow any body elses box and test it with theres ?

[r1c4ard]

Can you borrow any body elses box and test it with theres ?

Unfortunately cannot get hold of another Sat box but the Dreambox was switching with a 2x1 switch I also have

[r1c4ard]

Settings I have already tried?

From main menu

setting then service searching

sat config.

Non-stnd user defined config

my 4 chosen sat's created all other deleted

in lnb config for each sat

LNB0 then LNB1 for next sat etc

LOF/L 09750
LOF/H 10600 (universal)
Threshold 11700

Unticked increase voltage

Next page

Toneburst None
DisEqC Mode V1.0
DisEqC Parameter A/A
Sequence repeat unticked
Fast DiSEqC unticked

then for next LNB1
DiSeqC Parameter A/B

and so on for remaining...

Also tried DiSEqc Mode V1.1
as above with DiSEqc Repeats One (Only have a 10 Meter run) and none
Uncommitted Switch None and unit 1
Only have Swap Commands ticked

[r1c4ard]

Loose F Plug on receiver now all working used 4 sat config A/A A/B B/A B/B