I have the darkstar 11 image on a 600 S box and have lost all the channels except the free to air. I tried using the images built in key updater but no joy. I also put a softcam.key file and rebooted the box, but no luck. anyone any ideas please ?????
-
-
I had problems with using Darkstar and .8W, it is to do with the sat config and the satellite.xml file. I switched to the Pli Jade and edited the sat config from 1.0W to .8W so that I could get 0.8W and 1.0W . -
I think if means digitv has gone scrambled again
Read the Rules here; they apply to Everyone.
___________________
In the good old days, I hadDM800s HDOpenbox S10
TM500
DM500s
90cm FortecStar dish
Maxx 110cm Dish
Technomate 2300 Motors
sigpicComment
-
Hi Alan,
Go to setup, service searching, Transponder edit, select the satellite Thor 2/3 you will see an box listed as Orbital Position make sure its set to 9 and then save escape back to the main menu.
Regards:
AlunComment
Comment