dm 800hd new setup

[willet]

just set up the dm800 hd its running on enigma 2 sim 201 bl 76
i just installed cccam 214 & 214 with newcs after a lot off hair pulling got to put some c lines in cfg file tested box but only got freeveiw on bootup i get a webinterface error could;t listen on dm ip 192 198 --- --- -43 what am i missing i have a dm 500 all set up and running on cccam 212 do i need to alter any other settings in cfg file or dyndns account ??????

[satmannwest]

On DM800 cccam.cfg goes in etc. newcs config goes in var tuxbox/config

[willet]

thanks m8
when i put the 214 with newcs in it was in 1 file not seperate is that the problem why i get the webinterface error could;t listen on dm ip 192 198 --- --- -43
can i copy my old cfg file to my new box i am only going to use my new box once it set up the clines are temp for testing

[davvo]

webinterface error

you get that when the wrong ip is set in the webinterface
go to the webinterface plugin
put in dm ip and save
then you wont see that error anymore

[ezferret]

the ip is usually 192.168.xxx.xxx are u sure that 192.198.xxx.xxx is correct
Check by pinging the dm ip

[willet]

thanks chaps i will take a look and let you know the results

[satmannwest]

if you go to system/network and click on adapter settings it will show ip of box at the top.

[davvo]

webinterface error

you get that when the wrong ip is set in the webinterface
go to the webinterface plugin
put in dm ip and save
then you wont see that error anymore

just to add to my post above

another way stop that error msg

go to the webinterface plugin

enable webinterface yes/no
set to no and save

then you wont see that error anymore

[deffc0n]

Flash diffrent image this is old drivers.

[willet]

thanks all but still no joy i checked all settings and all ok cant check webinterface ip in addons just cant see it bin through all thats in the box still getting error mesage do i need the webinterface i have a hard lead connection from router to dm
still only getting fta would it be better to flash new image and start again if so is there a edg nemisis for dm800 hd pro