dm800 help

[carloslfc]

Hi recently got my hands on an original dm800 hd. flashed using original gemini2 5.10 image and installed cccam 2.14. Updated cccam.cfg with supplied cline but i dont get any channels other than the free channels on all sats. Tried all things tna, question is to view a cline do i need to enable port forwarding on my router or is that just for hosting? Other than that will try the nabilo image later and see if that solves my problems.
thanks

[freck]

Make sure that you have chosen CCcam to be your default cam.
when you get the box it'll have just the common interface...goto blue button and change to CCcam if youve installed it and your cline goes to var/etc.You dont need to portforward anything and make sure that DHCP is enabled in the boxess network settings.
Freck
.s. if all that fails contact your supplier and check that the line is active.

[carloslfc]

Hi , yes done all that, have tried a few clines now too.
strange, as i said will retry new image later, thanks anyway

[freck]

Try the dream elite phoenix edition in the downloads section but flash the correct one to suit your box....theres ssl 76 and ssl82 for newer models.Thats the best image out there at the minute
A;so do a network test on your box in network settings..thatll tell you if your connected properly or not.
Freck

[freck]

Whoooow.....STOP EVERYTHING!!!!!!
Just re read your post and noticed that its an original receiver you have....I thought it was a clone.
Try out a pli image from here and see how you get on.
Its not very often we get original receivers on here
Freck

[carloslfc]

Thanks for your help, went with the Nabilosat v12 original image and this time it all worked ok.