HELP!!! DM800se original not working

[timer]

Hi
By mistake i flashed sim2SE_ssl82 instead of image. Box not working any more, shows R01: no ca found. Tried to dreamup and it uploaded flash loaded but does't allow to flash new image. Any ideas?

[lincsat]

Make sure you have the latest Dreamup, that is the correct method to recover the box.

[fahimjan]

Which dreamup you use ?

[benny/9]

Hi
By mistake i flashed sim2SE_ssl82 instead of image. Box not working any more, shows R01: no ca found. Tried to dreamup and it uploaded flash loaded but does't allow to flash new image. Any ideas?

**************************************************
first make sure you use the correct firmware for your model
from dream multimedia site then do this.
************************************************** ****
To Manualy update firmware on a DM 500HD and the dm800se hd models
via mini-usb service port & Lan Network

Items required:
1) A TO B mini-usb male to male [same as a camera USB] & Cat5 Network Cable

2) Universal DreamUP 1.3.3.7 loader panel and the official software
for your model plus if needed the (USB to UART Bridge Virtual COM Port (VCP) driver)
from :-dream-multimedia-tv.de/en/downloads website

Process:

1)Unplug the Dream 500HD/dm800se turning off with the switch on
the rear panel is not enough dont try a short cut it could fail

2)next connect the cable for its part mini-usb port and
"Service" of the Dream 500HD and the USB to a USB port on your PC
and also the Lan Cable from your Router

3)Just plug it in, the PC will detect new hardware connected to the system:

4)The PC will ask the driver for this new component,
Windows 7 will download the driver Automaticly for you
the driver is cp210x usb to uart bridge controller

5)Open the Windows Device Manager,
and you will see the new hardware installed,
will appear as COM port (even a USB cable).
In the following example, is recognized as the cable into the port COM4.

6)next opened the universal DreamUP 1.3.3.7 [this is the latest version]
and select the update COM port (like any other model of Dreambox).
At this point, we choose the COM port that we appeared in the previous step
(COM4 in this example).

7)Press the Connect button the DreamUP universal panel and then go to the
dreambox and power it up to turn on again now the Dream 500HD/800se will
now to start loading new firmware.and once compleated exit the loader panel
and the dreambox will boot up again and then you can re-flash anouther image

**************************************

[alom5]

i used sunray to flash my 800se. i didn't know dreamup was available for it.