Motor Dish Problems

[kenny_c]

I have had my dish set up on a motor for about 5 months and everything was going fine until this afternoon, when my dish will only find the sats in the West, not East, anyone know why this would happen or if i can delete usals and add them again?

[The fat man]

It could be a motor problem or image problem! I would try a reflash of the image first and if you have same problem then its more than likely your motor.

[kenny_c]

Thanks, i will give that a go!

My motor goes from 30w to 4.8e, but no further for some random reason...

I bought my box already flashed so this shoul be fun putting on a new image!

[mickm1]

Thanks, i will give that a go!

My motor goes from 30w to 4.8e, but no further for some random reason...

I bought my box already flashed so this shoul be fun putting on a new image!

Have u maube set restrictions for the dish to move east?.. i did tis before when i did an insal to avoid the dish hitting the wall and completely blocked it from moving east by accident... just go into set up, service search then positioner set up.

[kenny_c]

you absolute beauty! that must of been it, i dont know how this has happened, but it did!

All sorted, thanks loads.

[mickm1]

you absolute beauty! that must of been it, i dont know how this has happened, but it did!

All sorted, thanks loads.

Easy done m8 if ur in that section... i tend to avoid it now myself .. glad u got it sorted tho

Mick