motorised Selfsat HH90 and DM800HD PVR clone --> rotor moves continuously

[bibicu]

Hi all,

I'm really in trouble with my receiver/dish....

After working swiftly for a couple of months, the dish (rotor actually), keeps moving continuously around the desired direction: say I point to 0.8W, the n the dish moves a bit to the left, then a bit to the right, then again to the left, etc, permanently.
Verry annoying, only power down of the DB stops the antenna movement...

I've tried reboot, reset to factory defaults (Enigma2 image), reinstall channels & frequencies, nothing helped

I'm not sure if my DB or my rotor is cracking up.

Can anyone help?

Thanks,
Daniel

[sj5301397]

Hi all,

I'm really in trouble with my receiver/dish....

After working swiftly for a couple of months, the dish (rotor actually), keeps moving continuously around the desired direction: say I point to 0.8W, the n the dish moves a bit to the left, then a bit to the right, then again to the left, etc, permanently.
Verry annoying, only power down of the DB stops the antenna movement...

I've tried reboot, reset to factory defaults (Enigma2 image), reinstall channels & frequencies, nothing helped

I'm not sure if my DB or my rotor is cracking up.

Can anyone help?

Thanks,
Daniel

i Had the same problem i was using sky twin cable which not good for motorised i changed it to a good thick cable(virginmedia Cable)
and now it works 100%

[EcuDoctorAlex]

change cable thatsall