Dm 800 hd motor set up

[sambhi92]

Hey guys,

Finally got a DM 800 hd, got the Gemini 5.1 image, was wondering, how to move the motor to set up new satellites and fine tune it to get best signal?

Cheers guys.

[gji25]

go to your tuner config and set up as expert.
then use usals and enter your longitude and latitude (multi map) can be a bit hit or miss at first but your have loads of fun getting it right. or you could read the stickies

[sambhi92]

Sorted that mate.

Got another issue now, I've set up 28e, 19e, 16e and 13e, when trying to set up 30w, 0.8w, 4.8e and 7e, I got into position setup and go into tune but cannot get the 2nd set of sats? Anyone know why?

Cheers guys.

[portbhoy]

Your setup must be slightly out, best thing to do is to go to 0.8 west bbc world news and tweak the dish left and right up and down till you get a signal. Your dish should track ok after that.

[sambhi92]

Cheers for the help mate, but i think i didnt post it a right way.

When going into tune, and trying to change the sat to either 30w, 7e, 4.8e and 0.8w, it doesnt show, it only show 28e, 13,e and so on, not the others ones, therefore i cant get those sats, I had them on dm 500s so i dont think its set up issue, its just getting the sat to show.

Any help?

[Fergal]

Go into satfinder option and choose them there.

[sambhi92]

Its shows when i go into service set up and chose the tuner, i can set the sat up, I.E, Which LNB, USALS or non, i got none btw.

Just when going position finder to tune the set in, i press red to pick which set, then go pre defined TP, and cannot get 30w, 7e, 4.8e and 0.8w?