Flashing DM800 problem!

[yamar1]

i bought a com port card off ebay and installed it into a spare slot on my desktop pc, works a treat with dreamup, around a fiver.

[danijel79]

thank you.it work

[Stardust Dreamer]

Oh! Finally found people chatting about bricked 800HD in English. My box is genuine and work well until it was flash with Nabilosat E2 Black Hole v0.12. My problem appears unique, in that the box worked fine but it would not allow me to connect to the box via the Webinterface. I found this out when I wanted to experiment with other images. And when it was not seen by Dreambox control center E2 {Error 1057 in function Send Socket is not connected} I could download add-ons via the box so it was on the net. Network setup showed that the box saw the router on the network and all parameters were ok. But it acted as if behind a firewall. Then I tried the serial port method, no response. [null modem cable/dreamup 1339] Eliminated cable or dreamup by getting the same setup to work with a DM500c box and Viewsat 2000 box so cables connections are correct.
The shit hit the fan when I connected a hard_drive. It bootup until it got to load enigma2 then just continue to do so with different colours on each reboot.
Never ask if something could get worse, it usually does. Any ideas?

[manutdawy]

I have CA not found problem, and when I use dream up with null cable, it just says "failed flashing (crc 002 error), your dreambox is now unusable, any help please?

[stew86]

found a software called NCF SIM2 v2.5 run software and put your image on it should work

[Stardust Dreamer]

I have used dreamup and other programs flash my 800HD box with the same results. The box doesn***8217;t respond the null-cable at all. My box is an original Dream Multimedia box with S\mcard A2p installed that is glued in by the manufactures. If the cable is attached the screen goes blank and the ethernet lights stays on with out blinking. Dreamup seen to help clone box why not mine an original box?

[dalir]

After "CA not found" I connect my DM800 SE HD clone and get message: "waiting for acknowledge". It is stop on it.
Any help?

[Wolfair]

Got the same issue

[icke123]

same problem here with DM8000. Ill try now with enforcer.

[andy91]

Would help most of you if you started your own thread and forum members would be able to follow the thread instead of posting over other members threads.
All the answers are on the forum if you use the search button.

Andy.