tut/dm800

[jumpinjo]

hi guys, flashing np's with NiabloSat V0.12 but bit am struggling with is when i get to tuner configuration, now av just got ma head round the 500 and had sussed out but its went tits up, is there any tuts i can get to help me, and can i install cccam with blue button/addon like 500.

Thanks

[bugaloo41]

Joe sorry mate dont have one but found this - hope it helps. Credit to MCC

Flashing a new firmware (image) by Browser

What you need to flash
You need the image file you want to flash. Image files have the extension *.nfi. You can't flash other
images like *.img files. Don't try it - it won't work.
You need either a DHCP server, a configured bootloader or a serial cable and a terminal program
like HyperTerm.
You need a browser, and a network cable. If you connect the Dreambox directly to the PC,
you need a cross cable, if you connect trough a switch/hub/router you need a normal
(non-cross) cable.
To flash a new image, you can use the second stage loader. It must be present and not broken.
The following steps assume you have a DHCP server. If you don't have one, you have to setup
an IP address in the bootloader's serial setup.


- Power down the Dreambox, either using "shutdown" and by removing the power connector.

Standby is not enough!



- (1.) Press and hold the power button. Replug the power connector into the Dreambox.
- (3.) A text "*** STOP ***" should appear. Now you can release the button.
The bootloader entered the "waiting" mode.
- (4.) Above the "*** STOP ***" text, there should appear an IP-address
(four decimal values with a dot in between). If there appears the string "dhcp" instead,
the box still searches for a DHCP server. Wait a bit. If it doesn't change, something doesn't
work with the DHCP server. Check wether network cable is plugged in etc. If it just doesn't
work, set an IP using the serial terminal)



- Now, open a browser on your PC.
(1.) enter in the address line "http://ip/" (where ip must be replaced with the value in the LCD).
- (2.) on the bottom of the page, there's a link called "firmware upgrade". Click it.


- On the next page, you can select the flash image you want to flash. be sure that it has the ".nfi" extension.
You can't flash other images (like .img)!
- Click on "FLASH!" and wait. It might take some time to upload and flash the image.
- Switch the box off again, and on again. The new image should be flashed and working.

[jumpinjo]

cheers boogy but flashing it was np's

ive managed to get it scanning what i want and just doing the now but do you know directory to maually ftp cccam to

update

all sorted