If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Today my motor has went funny. If I go to any satellite it shows no signal but if I turn my settings to single lnb I get full signal. Does anyone have any ideas as to why?
Hi. I have installed many TM2600 motors and in my opinion they are brilliant. Is the motor moving the dish to correct satellites? If yes then its not the motor. Check your LNB etc and also if possible try it on a different receiver to eliminate LNB tuner problems.
Comment