Some tm5402 m2 help again pls

[taffyojones]

All up and running. But got one prob.
When I store my sats via my motorised sys.
i start of with 1% west and go from there. But no matter wot sys I uses. Eg. Disq or usals. When I try to select a sat. My motor goes past the one I want. This happens on all off them. Inc 1% west. I have done a reset on the motor. Still the same. Any ideas would be great.
thx rob.....
ps all my setup was done by professional installer.

[Nutsandbolts]

Hi. Very surprised that it was done by a professional installer...Your problem appears to be alignment if its going past the sats. Also if using USALS it could be your latitude and longitude settings are incorrect. You need to realign your dish on the correct satellite if using USALS . If using 1.2 you need to move the dish manually until you get a picture or signal and then save the positions . Remember USALS is the automatic search and 1.2 is the manual search. I prefer to use USALS as it saves a lot of time. You could always ask the professional to come back and sort it out.....

Regards.

[taffyojones]

Thx for that mate.
like I say have tried both usals and 1.2. And adjusting lat and lon. Still same prob.
bin in touch with installer. He's coming b to check it all out.
thx again rob....