Big Trouble with Plugins

[erinville]

TM Twin OE
Open Pli 4D

I'm trying to send Rats Bouquets to my receiver via DCC as I have no bouquets.
DCC sends it but it does not appear in my plugins.
Is there a way to force it to send by a command.
If so, I would be grateful if it was explained to me in laymans terms.

[digicon]

Upload ABM (Autobouquets) this will be much easier in the long run, And you can alter any specifics of ABM in the main menu to your liking

[erinville]

Where could I alter channels & is there a guide on how to do this?
If the power went out would it affect my changes?

[erinville]

I sent ABM to my receiver but it's not in plugins.
It's in Install Local Extensions.
I installed it from there & restarted my receiver, but it's still nowhere to be seen.

[digicon]

Have you had a look in the Service Searching menu as the Main Plugin and setup page is normally located there.

[erinville]

Before I read this I sent what I "thought" was an Autobouquets Maker to my receiver & when I restarted it was something totally different.
I tried reflashing with Open PLI 4 D again but it won't even override what is now on the receiver.
I guess this is what they say about "bricking" the receiver.
Now I have no menu & more importantly I have no full factory reset.
Any way to get full factory reset back?

[digicon]

Might be worth a try to load another image say OpenATV or OpenVix to see if you can get the receiver back accepting the image upload, by the way OpenATV & OpenVix contain ABM by default

[erinville]

I tried Openvix.
I'll try OpenATV tomorrow.
I've tried about 5 already.

[cactikid]

i aint moved still on vix,and abm works fine.

[erinville]

Is Vix Open Pli?

[cactikid]

open-vix is an image like blackhole and open pli,think when a box boots up with vix image picture of waterfall
on booting

[erinville]

Thanks for the info.
No matter what image I try to flash I am getting no joy.

[erinville]

Success at last.
I loaded OpenATV & I still had the same screen.
I then loaded a bootloader & after that I loaded Open ATV & it worked.
I did a scan & got my channels back.
I had trouble entering my cline, but I got it going eventually.
The only trouble I have now is that I can't mount my external HDD.
It tries to mount through the menu, but a message comes up saying "timeout elapsed, sorry".
I tried through Network but no joy.
I wonder if there is another way to mount this external HDD?

[cactikid]

storage devices let it scan for them,it should list usb [ hopefully been used for epg ] and external hdd,usb and hdd both need to be initialised and ext3 to ext4.

recheck in setup mounts green button? that it says usb [ i use 8gb ] and not hdd
and underneath the name of hard drive and size to hdd.

[erinville]

No Joy.
I reverted back to the 4D image & I'm opening up a new thread looking for advice as to how set up Autobouquets Maker inl Open Pli 4D.
Many thanks for your help.