TM 5000 series and softcamsThis week I have tried to update a couple of TM5000 supers

[excollier]

This week I have tried to update a couple of TM5000 supers ( a 5200 USB and a 5300 USB ) in the usual way, for Bulsat.
Trouble is I unzip the softcam files and put them onto the usb stick, but when I put them into the receiver they don't show up on the screen so that I can load them to the receiver. When I put the usb stick back into the computer, there it is. What's going on? I have been doing this for about two years now did something change in the last couple of weeks?
The last softcam I put in around 16/11/11 or so with no problems.
What is going on????
I am using the TM patch from August, version 116

[evens]

had same problem so had to use firefox and 7 zip now they open no probs

[excollier]

had same problem so had to use firefox and 7 zip now they open no probs

I have been using Firefox for two years now, and Izarc to unzip them, as usual, so nothing there has changed.

[Manic01]

Softcams wont show unless patch is turned on.
Menu-system info- If you dont see Cas/Biss menu then patch is OFF.
Press 2004 into remote control to see these menus.

[excollier]

Softcams wont show unless patch is turned on.
Menu-system info- If you dont see Cas/Biss menu then patch is OFF.
Press 2004 into remote control to see these menus.

Thanks, I re-patched with latest Phantompatch and then the receiver immediately "saw" the softcam and I was able to load it on