help v0+clone dont boot anymore

[jj2]

i had try to update my vo+clone to version 2 whit my omoddelcabel i try from winxp to update the update start fine
put i stant still for about 2% of the update an nothing
more happing it dont finish the update now the v0+clone
dont start anymore it just show starting in the display and nothing happings is the a way to flash i back with the omoddelcabel
thanks jj

[benny/9]

i had try to update my vo+clone to version 2 whit my omoddelcabel i try from winxp to update the update start fine
put i stant still for about 2% of the update an nothing
more happing it dont finish the update now the v0+clone
dont start anymore it just show starting in the display and nothing happings is the a way to flash i back with the omoddelcabel
thanks jj

*************************************************
have a look at the attachment and do that way

[jj2]

big thanks benny/9
but after many try its udate 100% but now when i put power on i can hear the vo+ run but there i only a little red light
in the display and nothing happing i thinks my clone vo+
is broke

[benny/9]

big thanks benny/9
but after many try its udate 100% but now when i put power on i can hear the vo+ run but there i only a little red light
in the display and nothing happing i thinks my clone vo+
is broke

***************************************
if your sure you have updated the box with the rs232 board
and the null modem cable, then put a image on a usb stick
and see if you can now flash the box first tu rn the box off
with the switch on the back panel, then put the stick in the
front usb port and turn the box back on and it should say reading usb
on the box lcd screen leave it to flash the box just follow the info/instructions etc;
on the lcd screen on the box untill it says remove usb and re boot
then remove the usb and turn the box off and give it a few seconds
and turn on again then the box should be flashed and ready to set up

[jj2]

i thanks for you big help benny/9
but nothing happing when i turn power on there is only a
red light in display and nothing happing

[mdt]

i thanks for you big help benny/9
but nothing happing when i turn power on there is only a
red light in display and nothing happing

why did you do the ic update if your box is a version2 as it already has the update pre-installed at the factory,regards mdt

[jj2]

no is was a version 1 but i think the botfil is gone or maybe i all broken is there not a way to flash it back to factory version

thanks

jj

[benny/9]

no is was a version 1 but i think the botfil is gone or maybe i all broken is there not a way to flash it back to factory version

thanks

jj

********************************************
first mate did you use the duo_scret file when
you updated the box? with the null modem cable
if not i have added it to do the update again
if you want to try the official vu firmware
you can find it here:-- Archive of Vu+

make sure you use the file for your model