OPEL CORSA D IMMO FAULT

[carmoh]

Hello, I have a 2008 Opel Corsa D with an immobilizer problem. I have the PIN code tested on OPCOM. I have two fault codes on the engine control unit: P1632 and P1679.
ECU: BOSCH ME7.6.2
BCM: DELPHI.
I need the BCM+ ECU and Dash CAN connection.
Or if someone can perform an immo off on the ECU, or virgin state
Thanks in advance.

[Faraday]

Do you have environment identifier error in other modules?

[carmoh]

YES with IPC SMD

DIS KO NO COMM

[foxtec800]

reset bcm with tech2 or similar and reprogram,, its a known issue due to battery voltage

[ginodilegno10]

You solve also with OPCOM, reset BCM, ECU IPC and reprogram....

[Faraday]

YES with IPC SMD

DIS KO NO COMM

USE Tech2 it will guide you by hand.

[Bllinda]

Hello, I have a 2008 Opel Corsa D with an immobilizer problem. I have the PIN code tested on OPCOM. I have two fault codes on the engine control unit: P1632 and P1679.
ECU: BOSCH ME7.6.2
BCM: DELPHI.
I need the BCM+ ECU and Dash CAN connection.
Or if someone can perform an immo off on the ECU, or virgin state
Thanks in advance.

You need to read mcunec

reset bcm with tech2 or similar and reprogram,, its a known issue due to battery voltage

You solve also with OPCOM, reset BCM, ECU IPC and reprogram....

USE Tech2 it will guide you by hand.

They are all right

[Manta1600]

You need to read mcunec

Autel read the BCM pin by OBD

[Bllinda]

Autel read the BCM pin by OBD

And what will you do if MW93C86 and MCUnec are different crypts?

[Manta1600]

And what will you do if MW93C86 and MCUnec are different crypts?

I never checked what is inside as always when I needed to read the pin from BCM by OBD was successful

Also as the BCM belong to this car you can read the pin from few other modules

[carmoh]

Hi my op com china clone havn't option to reset IPC only bcm and ecu

[Bllinda]

Also as the BCM belong to this car you can read the pin from few other modules

You need to go to the dtc.

Power – Wrong Transponder Key 
P – Wrong Environment Identifier Received BCM_(BodyControlModule)

[Manta1600]

You need to go to the dtc.

Power – Wrong Transponder Key 
P – Wrong Environment Identifier Received BCM_(BodyControlModule)

And what ???

You can have this code in 2 situation

1st - when someone already reseted the BCM and left it not programed
2nd - Someone fitted BCM from different car

If the Autel can't read the pin by OBD I will read it on bench or I will supply BCM that can be read by OBD from the scrapyard

[Bllinda]

The story is endless and it will be charitable

2nd - Someone fitted BCM from different car mw-c86