CARPROG FULL

[xlinuxasx]

Hello, I want to read my vw ecu, but in all Carprog versions Im trying, it is N/A. Is there any solution to make these functions working? Im using chinese clone. Thanks.

123.jpg

[javyb]

Hello, I want to read my vw ecu, but in all Carprog versions Im trying, it is N/A. Is there any solution to make these functions working? Im using chinese clone. Thanks.

123.jpg

Because there is no device attached look at screen bottom left should display serial number

Sent from my SM-G935F using Tapatalk

[xlinuxasx]

When Im connecting device, i got this message:
222.jpg

[mara07]

It's will work with the adaptor A1+ .
And the firmware must be FULL
CARPROG1121.JPG

[ubistvo]

OK
I need help
Passat B6 2007 i try to change km with carprog but all time i got message "connection error"
What is the problem??
Last year i try on similar B6 and i make change on km
What is now problem??

[lupu_sandu]

Adapter A1

[ubistvo]

OK
What adapter A1???
Can you help me

[lupu_sandu]

OK
What is now problem??

Adapter A1

You got your answer to the problem

[Seby_TM]

You need to check if you need power supply on carprog +12v !

[Bllinda]

Sorry for the question off topic. In order not to create a new ....
Is everything works car.prog 8.21and the9.31 off-line? Thx

[gokart]

I have UART1 - error during testing with A9 test adapter. Do you have any solution for this? It's original one and I have already replaced all 74HC125M.

[FxShaw]

I have UART1 - error during testing with A9 test adapter. Do you have any solution for this? It's original one and I have already replaced all 74HC125M.

Usually get that error if you don't replace the resistor too or solder wrong spot..Did you make the A9 adapter yr self?

[gokart]

Usually get that error if you don't replace the resistor too or solder wrong spot..Did you make the A9 adapter yr self?

Thank you for your reply. The resistors and soldering are OK. I made the adapter which is 100% correct. Finally, I solved the problem. It was a small manufacturing problem on the PCB. Now, works fine.

[FxShaw]

Thank you for your reply. The resistors and soldering are OK. I made the adapter which is 100% correct. Finally, I solved the problem. It was a small manufacturing problem on the PCB. Now, works fine.

Can we see a pic of that and where it was just in case someone else have the same issue in the future?

[Levanime]

Sorry for the question off topic. In order not to create a new ....
Is everything works car.prog 8.21and the9.31 off-line? Thx

+1 question not to create new thread

source to buy good quality car prog full?

thanks