VAG-COM/VCDS EVERYTHING

[mrgaga]

Hi,

It is possible to update this cable

What can I connect to j2

20170301183835_31300.jpg20170301183914_91527.jpg

[Moldovan1]

Ok but not remove from PCB ? Only wire solder to chip on PCB ?

No need remove. Wires to chip on PCB.

[alexm1]

I do not see Atmega on pics posted above....dumps shared here will work with any chip?

[Domi]

no only with atmega162

[mrgaga]

Hi , i play with the solution from kolimer .
I have a old cable 11.11 with HW 0x44 updated.

Now i have a error

error.jpg
what do i wrong
solution:
Files are missing in the folder

[deluss]

I have update my atmega in cable hw 0x44, but when i try to scan in VCDS craced, with external 12v i see " interface not found", but when i off external 12v and then try to scan i see " inferface found but not pluged to car".
What i need to do after update atmega (flash and eeprom) ??
Need also to ftdi ?? (i try to change ftdi with mprog but when i try to prog i see "no interface found".

[uragan1987]

deluss install the driver for USB Interface and then try to locate it with mprog

[deluss]

I install this drivers: CDM-2.08.28-WHQL-Certified, and still have problem with MProg.

http://imgur.com/a/Oxo8G

[Domi]

I have update my atmega in cable hw 0x44, but when i try to scan in VCDS craced, with external 12v i see " interface not found", but when i off external 12v and then try to scan i see " inferface found but not pluged to car".
What i need to do after update atmega (flash and eeprom) ??
Need also to ftdi ?? (i try to change ftdi with mprog but when i try to prog i see "no interface found".

it's not problem with ftdi, reflash atmega again and check fuses

edit// ok, you have erased ftdi flash again

[uragan1987]

install deluss last FT_Prog 3.3.80
and do the same as at the video3.avi
https://youtu.be/HsDqpbKsK58

[deluss]

I try do the same like you on film but i have error. I think i have wrong file or my cable need one more time to change atmega.
http://imgur.com/a/ApKeA



//edit I repair this problem. I change in my .xml chip numer from FT232R to FT232/245BM
When i test cabel in vcds, i have on every click different message.

https://ibb.co/gnkwNa
https://ibb.co/esY5Fv
https://ibb.co/kBPZ8F

[Domi]

maybe

http://www.digital-kaos.co.uk/forums...iled-Self-Test!

[liviudiaconu]

@Dellus: You have FT232BM/BL or FT232R?

Because in your images i see FT232B with FA24... not so good.
I suppose you not use correct file.

[deluss]

I open my cabel and inside is FT232B.

So what i need to repair my vcds? with file is good ? I need reprog atmega one more time ?

[cypher007]

ok downloaded 17.1.3v2 and have hooked up my 0x46 via the pin header to usbasp, and extreme burner sees the chip. how do I go about flashing it? sorry need a step by step.