BDM CONNECTIONS FOR XPROGM

[pandokrator]

i have this ecu (second pcb from marelli MJD for 1.3cdti corsa D)
in BDM info pdf probable the pin1 is wrong.
Any tested diagram ?
thnx

marelli_1.3_MJD_MPC563

[darwins]

Well after some more searching I found this PDF which came with this BDM I bought a while back: https://rapidshare.com/files/4419021...rog_PE_ENG.pdf

I'm not using this BDM for the job because I don't seam to have the algoritham Anyone have one ?

I have a clone BDM100 & clone X-ProgM.

I have opted for Xprog on this, ground pins have been identified I have tried a selection of pin out options (powering ecu up stand alone) but Xprog shows the screen attached it just sits there which is sort of a result, better than the silence treatment

Any help or suggestions would be great.

The car aparently runs with this ecu so I don't think this is the problem..

Thanks

Darwins


NOW SORTED

[eprommazza]

i have this ecu (second pcb from marelli MJD for 1.3cdti corsa D)
in BDM info pdf probable the pin1 is wrong.
Any tested diagram ?
thnx

marelli_1.3_MJD_MPC563

Hi guys I do not use x prog m bdm
but I see that the connections are wrong
I made a pattern for me
if someone wants to try it

Download magnet10.jpg from Sendspace.com - send big files the easy way

http://www.sendspace.com/filegroup/4...Uia9u1JcQWYIhQ


http://www.sendspace.com/filegroup/G...SLuEJRlKbkjKVg

tested 100% no need adapter 9s12 for this...
448kb dump are ok 100% are full without eeprom i chek also chksum with winols ricognize ok 100%
for read eeprom select mpc eeprom and read also
x prog m can read write this without problem
only the best
eprom!

regards

[eprommazza]

I see that many here talk talk but did not understand anything
I had 5 minutes and I thought to try
to raise doubts

regards