3 rrod xbox's

[pspmixer]

just bought 3 rrod xbox 360
2 elite console
1 arcade conosle

anyone know how to fix this
as id like to flash them at some point if can be fixed

[pauleemor]

try a new power supply first as causes rrd

[pspmixer]

so swap one inside the console or new lead

[bowie]

look on youtube. loads of vids showing you how. did mine a few years back

[pauleemor]

power supply that you know works did my daughters this week as had rrod changed power lead and works 100% now

[pspmixer]

look on youtube. loads of vids showing you how. did mine a few years back

p.m one used or comment it on here

power supply that you know works did my daughters this week as had rrod changed power lead and works 100% now

ive only got one lead where can i get one

[pauleemor]

try a friends that you know works and see result before you buy you can pick up from about ?20

[cunny]

Get secondary code.

Strip down so motherboard is out.
Remove xclamps
Clean up cpu and gpu
Buy some machine screws
Replace xclamps with decent thermal paste.
Put kpads on ram chips
Reseat board.
With fans disconnected power up console allowing to over heat
Once over heated power off at mains
Leave for 20 mins to cool down.
Recollect fans and power up

Sent from my GT-I9300 using Tapatalk 2

[cunny]

You can also buy rrod repair kits from xecuter. Think it's the extreme edition now

Sent from my GT-I9300 using Tapatalk 2

[pspmixer]

You can also buy rrod repair kits from xecuter. Think it's the extreme edition now

Sent from my GT-I9300 using Tapatalk 2

are they good and do they work

http://www.modtraders.co.uk/xecuter-...t-version.html
http://www.modtraders.co.uk/tx-xbox-...e-edition.html
http://www.modtraders.co.uk/xecuter-...-10-xboxs.html

[cunny]

Never used 1 however I'd imagine they work as from xecuter.

I've repaired a few with above method

Sent from my GT-I9300 using Tapatalk 2

[bowie]

i did exactly what cunny has mentioned. can't remember which vid i followed mate. but there are plenty to follow. tbh though i had the rrod again about 9 months later and had to clean it up again. it looks tricky but it really isn't

[bowie]

you can also buy rrod x clamp repair kits on fleabay

[pspmixer]

manged to get number of the elite console
one was 0110 green light on power brick
other was 0001 red light on power brick

i couldnt get numbers of white xbox as tray kept coming out it didn have 3 red lights on front
but what i weird is when i plugged av leads in turned on the console it works no red rights or nothing (could i flash this one then )

for all them i used a new power brick and lead as just bought one off amazon for ?8 and no hard rive on any of them

[ezzda1]

0110 = E20: likely a Ram error, this can be caused by a cold or bridged solder joint on one of the Ram chips. reflow the ram area with a hot air reflow station.

0001 = E01: possibly a power supply problem, if it's been tested with known working power supply it's most likely a blown mosfet on the motherboard, time to crack the multimeter out to test the mosfets. and check for any short circuits on the board.
like this
Forums.Xbox-experts.com - an easy way to fix 0001/0002/0003

i couldnt get numbers of white xbox as tray kept coming out it didn have 3 red lights on front
but what i weird is when i plugged av leads in turned on the console it works no red rights or nothing (could i flash this one then )

if it boots up and displays picture and has sound, yes you can flash it.
just make sure it plays original games before you mess with it,
if it doesn't you may be looking at a bad laser or lost drive key depending on what it can play.