Digiprog 3 clone questions and answers

[autocargo]

It should be right, becouse a friend tried to with his digi but same thing... It try then error.
Have you done some with st 27?

Recheck your soldering point on instrument cluster. There are two types of clusters with its own soldering point. Follow carefully digiprog pdf. It should work.

[beti88]

Recheck your soldering point on instrument cluster. There are two types of clusters with its own soldering point. Follow carefully digiprog pdf. It should work.

I did that, and tryed with both types but without sucess. But it was a long time ago, we changed the instrument cluster and took one with lower milage

[Music73]

I did that, and tryed with both types but without sucess. But it was a long time ago, we changed the instrument cluster and took one with lower milage

I also couldn't manage to get mk1 focus to go with digi checked points and cable pin out.. Ended up taking mcu off the board and doing with xprog.. Tbh I always seem to have grief with these dashes... done about three of them and always have trouble even with tacho universal only ever managed with xprog and even that can be hit and mis...

[lupu_sandu]

I also couldn't manage to get mk1 focus to go with digi checked points and cable pin out.. Ended up taking mcu off the board and doing with xprog.. Tbh I always seem to have grief with these dashes... done about three of them and always have trouble even with tacho universal only ever managed with xprog and even that can be hit and mis...

Smok DashDiag make them via dash connector. No boot pin required.