My scan is finding transponders but no services??

[sbance]

what frequency do i use - i know i am 6952 but dont know the frequency to set

[moselep]

try this file mate...............

[sbance]

thanks mate, will try tonite and let u know how i get on - thanks

[sbance]

OK still no luck! even tried a manual scan - does anyone have any suggestions please i am running out of patience with this box. i think my tuner is ok coz i get BER. i can confirm that my cable feed is ok coz my dbox2 works fine, and it is the same feed. I am running out of hope!!!!

[alexh]

i think my tuner is ok coz i get BER.

BER = Bit Error Rate and should be zero always. Anything other than zero means data corruption on the incoming signal.

[sbance]

when it searches for transponders, the BER varies in value, when it locks a transponder, the BER is Nil and then i start the scan for services - do u think the tuner is OK???

[freck]

when you enter the 6952, on transponders does it say lock and sync ?

Is this a screenshot of the box in question???
Thats a sat box,if not try the updated evocam2.17 or the hypercam fix.
Personally the Jade image is a very good image and works very well but tricky when things go wrong,why not try a Cli image and see how you go.Do a flash erase first then put the Cli image on.
Nothing to loose.

[sbance]

No that is not my screenshot - its a screenshot of one of the members who was helping me. I think i'll try a Cli image as suggested - can you recommend any one??

[alexh]

when it searches for transponders, the BER varies in value

I cannot say for sure but I believe that is normal. (Sorry but I cannot be arsed to try it out).

Some of the frequencies that it tries will not have any signal which would explain a non zero BER.

[freck]

pm sent sbance

[sbance]

THANKS GOT YOUR MSG MATE - WILL TRY IT OUT AND LET YOU KNOW

[sbance]

OK guys i have installed a CLi image - but i have exactly the same results!! The scan can find plenty of transponders but can find no services/channels!!! What is wrong with the box - is it the tuner - if so, how easy is it to change the tuner in the boc - i see they are plug and play - any help would be appreciated

[sbance]

HI all, i have managed to figure out what was wrong with my dreambox. the tuner has slightly come out of the slot and therefore was giving me all of these problems. when i opened the dreambox up, i pushed the tuner back in its place and BINGO!!!!
I thought i'd write this up just in case some of you have the same problem that i did!

THANKS TO ALL!